HP DesignJet Z5200 series - Front Cover Removal

21:YZ
Cause
Solution
Fail moving Service Station. Try the following:
●
Switch the Power OFF from the back of the Printer and
disconnect the Power cord. Check the Primer Tubes.
Reconnect the power cord and power On the Printer.
●
Make sure that the Service Station path is clear. Remove
any visible obstacles (e.g. screws, plastic parts, etc...)
restricting the movement of the Service Station.
●
Perform the Service Station diagnostic test to
troubleshoot the problem further
8. Service Station
on page 110.
●
If the System Error continues, replace the Service Station
refer Service Station on page 214.
●
If the System Error continues, replace the PrintMech PCA
refer PrintMech PCA on page 220.
21.1:YZ
Cause
Solution
Service Station servo shutdown. Try the following:
●
Switch the Power OFF from the back of the Printer and
disconnect the Power cord. Check the Primer Tubes.
Reconnect the power cord and power On the Printer.
●
Perform the Service Station diagnostic test to
troubleshoot the problem further
8. Service Station
on page 110.
●
If the System Error continues, replace the Service Station
refer Service Station on page 214.
●
If the System Error continues, replace the PrintMech PCA
refer PrintMech PCA on page 220.
54 Chapter 2 System Error Codes ENWW
www.Partshere.com
Partshere Troubleshooting