4. Add 2 or 3 drops of oil in the depression where the Slider fits.
Color Sensor (ESP)
Removal
NOTE: Switch off the printer and remove the power cable.
1. Remove the Right Cover (refer Right Cover on page 185).
2. Remove the Left Cover (refer
Left Cover on page 188).
3. Remove the Front Panel (refer
Front Panel on page 203).
4. Remove the Top Cover (refer
Top Cover on page 205).
5. Remove the Window Position Sensor (refer
Window Position Sensor on page 208).
6. Remove the Ink Supply Tubes Support Rail (refer
Ink Supply Tubes Support Rail on page 209).
7. Open the Carriage Cover.
262 Chapter 6 Removal and Installation ENWW
To Next Page
Loading...