7. The front panel asks you to open the Window and the Carriage Cover.
8. The front panel asks you to remove the two printheads of the color you already selected (which
had the broken bag). Remove the printheads and press OK to continue.
9. The front panel asks you to introduce the needle of the syringe into one of the FI towers of the
selected color. Use the syringe from the Broken Bag Fixing Tools kit. Use the FI tower that is closer
to the rear of the Carriage, as shown. Press OK to continue.
10. The front panel displays a status message.
Ink is now pumping through the ink tube, pushing any air bubbles from the ink tube into the
syringe. The amount of ink pumped through the ink tube into the syringe is 33 ml + air.
11. After two minutes, the front panel asks you to confirm that there is now 35 ml of ink + air in the
syringe.
12. The front panel explains that the printer is accounting for the ink used.
13. The front panel displays OK, then asks if you want to repeat the procedure. If you want to repeat
(because there is still some air in the ink tube, or because more than one bag was broken), press
OK. Otherwise press Cancel and continue with the remaining steps.
NOTE: If you cannot clear the bubbles from the ink tube, replace the complete SRK Tubes
Assembly.
96 Chapter 4 Service tests and utilities ENWW
Service tests and
utilities
To Next Page
Loading...
