SE 27.8:01
Cause: Calibration failed to due to poor performance of the Matte Black/Red Printhead in slot 8
Solution: This may impact your print quality. If it becomes unacceptable in the future, clean all
printheads and check their status.
SE 28.1:01
Cause: Magenta/Yellow Printhead in slot 1 is deteriorating
Solution: This may impact your print quality. If it becomes unacceptable in the future, replace that
printhead with a new one.
NOTE: This system error appears only after the printhead is out of warranty.
SE 28.2:01
Cause: Magenta/Yellow Printhead in slot 2 is deteriorating
Solution: This may impact your print quality. If it becomes unacceptable in the future, replace that
printhead with a new one.
NOTE: This system error appears only after the printhead is out of warranty.
SE 28.3:01
Cause: Light Cyan/Light Magenta Printhead in slot 3 is deteriorating
Solution: This may impact your print quality. If it becomes unacceptable in the future, replace that
printhead with a new one.
NOTE: This system error appears only after the printhead is out of warranty.
SE 28.4:01
Cause: Light Cyan/Light Magenta Printhead in slot 4 is deteriorating
Solution: This may impact your print quality. If it becomes unacceptable in the future, replace that
printhead with a new one.
NOTE: This system error appears only after the printhead is out of warranty.
SE 28.5:01
Cause: Photo Black/Light Gray Printhead in slot 5 is deteriorating
Solution: This may impact your print quality. If it becomes unacceptable in the future, replace that
printhead with a new one.
NOTE: This system error appears only after the printhead is out of warranty.
SE 28.6:01
Cause: Photo Black/Light Gray Printhead in slot 6 is deteriorating
52 Chapter 2 System error codes ENWW
System error codes
To Next Page
Loading...
