EasyManua.ls Logo

HP Designjet Z6200 - Page 64

HP Designjet Z6200
438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SE 28.4:02
Cause: Light Cyan/Light Magenta Printhead in slot 4 nearing the end of its useful life
Solution: This printhead may have reached a degradation level that prevents the printer from
producing acceptable prints consistently. If it becomes unacceptable in the future, run the Clean
(Recover) Printhead procedure.
NOTE: This system error appears only after the printhead is out of warranty.
SE 28.5:02
Cause: Photo Black/Light Gray Printhead in slot 5 nearing the end of its useful life
Solution: This printhead may have reached a degradation level that prevents the printer from
producing acceptable prints consistently. If it becomes unacceptable in the future, run the Clean
(Recover) Printhead procedure.
NOTE: This system error appears only after the printhead is out of warranty.
SE 28.6:02
Cause: Photo Black/Light Gray Printhead in slot 6 nearing the end of its useful life
Solution: This printhead may have reached a degradation level that prevents the printer from
producing acceptable prints consistently. If it becomes unacceptable in the future, run the Clean
(Recover) Printhead procedure.
NOTE: This system error appears only after the printhead is out of warranty.
SE 28.7:02
Cause: Matte Black/Red Printhead in slot 7 nearing the end of its useful life
Solution: This printhead may have reached a degradation level that prevents the printer from
producing acceptable prints consistently. If it becomes unacceptable in the future, run the Clean
(Recover) Printhead procedure.
NOTE: This system error appears only after the printhead is out of warranty.
SE 28.8:02
Cause: Matte Black/Red Printhead in slot 8 nearing the end of its useful life
Solution: This printhead may have reached a degradation level that prevents the printer from
producing acceptable prints consistently. If it becomes unacceptable in the future, run the Clean
(Recover) Printhead procedure.
NOTE: This system error appears only after the printhead is out of warranty.
SE 29:00
Cause: Maintenance Cartridge almost full
Solution: Replace the Maintenance Cartridge.
54 Chapter 2 System error codes ENWW
System error codes

Other manuals for HP Designjet Z6200

Related product manuals