To Next Page

To Previous Page

Operations 28

Release the full-length expansion board retainer, and then remove the PCI riser cage.

6. Remove the full-length expansion board.

Install the PCI riser cage

WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,

remove the power cord to remove power from the server. The front panel Power On/Standby

button does not completely shut off system power. Portions of the power supply and some internal

circuitry remain active until AC power is removed.

1. Power down the server (on page 21).

2. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

3. Extend the server from the rack (on page 21).

4. Remove the access panel (on page 22).

Storage Networks

www.storagenetworks.com

Authorized HP Reseller

Spare Parts:

http://www.storagenetworks.com/products/servers/hp/DL380G8/dl380pg8_servers_landing.php

Questions and Answers:

Need help?

Do you have a question about the HP DL380P and is the answer not in the manual?

HP DL380P Specifications

General

Product Line	ProLiant
Rack Height	2U
Processor Sockets	2
Memory	Up to 768 GB
RAID Levels	0, 1, 5, 6, 10, 50, 60
Management	HP iLO (Integrated Lights-Out)
Server Type	Rack
Processor	Intel Xeon E5-2600 series
Chipset	Intel C600
Memory Slots	24
Memory Type	DDR3
Drive Bays	25 SFF
Hard Drive Interface	SAS, SATA
Network	Gigabit Ethernet
Power Supply	Redundant Power Supplies supported
Expansion Slots	6 PCIe Gen3 slots
Operating System Support	Windows Server, Linux, VMware
Remote Management	HP iLO (Integrated Lights-Out)
Form Factor	Rackmount