HP E273m - TYPE-C Connector CN1504

22
3) Lift the CN5101 connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
5) Solder the new component.
TYPE-C connector CN1504
Repair the TYPE-C connector:
1) Use a soldering iron and a desoldering pump to remove as much solder as possible from the pin.
2) Use a hot air gun to melt the solder on the pins.
3) Lift the CN1504 connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.