3. Remove the Phillips M2.0 × 3.0 screw (3), and then pull the WLAN module (4) out of the socket.
NOTE: The #1 white WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2
black WLAN antenna cable connects to the WLAN module #1 Aux terminal.
4. If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective
sleeve on the antenna connector, as shown in the following illustration.
To install a WLAN module, reverse this procedure.
WWAN module
To remove the WWAN module, use this procedure and illustration.
Table 5-4
WWAN module description and part number
Description Spare part number
HP 4000 4G LTE-Advanced Pro N65633-005
IMPORTANT: To prevent an unresponsive system, replace the wireless module only with a wireless
module authorized for use in the computer by the governmental agency that regulates wireless
42
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
