Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Disconnect the battery cable from the system board (see Battery on page 48).
Remove the speakers:
1. Disconnect the speaker cable from the system board connector (1).
2. Remove the four Phillips M2.0 × 2.0 screws (2) that secure the speaker to the computer.
3. Remove the cable from the clips and tape (3) between the speakers.
4. Remove the speakers (4).
NOTE: When removing the speakers, make note of the location of the rubber isolators (5) in the
screw holes. The absence of or damage to these isolators can result in degraded speaker
performance.
To install speakers, reverse this procedure.
Fingerprint reader board
To remove the fingerprint reader board, use this procedure and illustration.
Table 6-3
Fingerprint reader board descriptions and part numbers
Description Spare part number
Fingerprint reader board N96242-001
Fingerprint reader board cable (included in the Cable Kit) N98721-001
Fingerprint reader insert (included in the Plastics Kit) N96234-001
Fingerprint reader bracket N96233-001
Before removing the fingerprint reader board, follow these steps:
Fingerprint reader board
51
To Next Page
Loading...
