1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Remove the battery (see Battery on page 48).
4. Remove the right speaker (see Speakers on page 50).
Remove the fingerprint reader board:
1. Disconnect the cable from the ZIF connector (1) on the fingerprint reader .
2. Remove the two Phillips M2.0 × 2.5 screws (2) that secure the fingerprint reader bracket to the
computer, and then remove the bracket (3).
3. Remove the fingerprint reader board (4) from the computer.
To install a fingerprint reader board, reverse this procedure.
Fan
To remove the fan, use this procedure and illustration.
Table 6-4
Fan description and part number
Description Spare part number
Fan N96441-001
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Disconnect the battery cable from the system board (see Battery on page 48).
Remove the fan assembly:
1. Disconnect the fan cable from the system board connector (1).
52
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
