4. Remove the plastic I/O bracket (3) from the right edge of the board.
5. Lift the side of the system board (1) upward, and then pull the system board (2) away from the
connectors on the side of the computer to remove it.
To install a system board, reverse this procedure.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for display assemblies are available
only at the subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Disconnect the battery cable from the system board (see Battery on page 48).
Remove the display assembly:
Display assembly
61
To Next Page
Loading...
