1. (Select models only) Disconnect the antenna cables (1) from the WWAN module.
2. (Select models only) Disconnect the WWAN cable from the system board connector (2).
3. (Select models only) Remove the WWAN cable and antenna cables from the routing channel (3) in
the RJ-45 door bracket.
4. Disconnect the antenna cables (4) from the WLAN module.
5. Disconnect the display cable (5) from the system board ZIF connector.
6. Remove the display cable and WLAN antenna cables from the metal clip (6) at the bottom of the
hinge.
7. Remove the six Phillips M2.5 × 4.0 screws that secure the display assembly to the computer.
8. Open the computer (1) to approximately 170°
62
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
