Base enclosure
Description Spare part number
Base enclosure L02251-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal and
replacement
Before removing the base enclosure, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
Remove the base enclosure:
▲
Remove 8 T8 screws, and then lift the base enclosure to remove it.
Reverse this procedure to install the base enclosure.
34 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
