3. (Select models only) Disconnect the antenna cables from the WWAN module (4), and then remove the
cables from the clips (5).
4. Remove the ve Phillips M2.5 × 4.0 screws (1) that secure the display assembly to the computer.
5. Rotate the display to open the hinges (2).
6. Separate the display assembly from the computer (3).
7. If you need to remove the bezel:
a. Flex the top (1), the left and right sides (2), and then the bottom of the bezel (3) to release it.
b. Remove the bezel from the display (4).
The display bezel is available as the following spare part numbers:
N00101-001: Models with an FHD display without a camera
N00099-001: Models with an FHD display and HD camera
Component replacement procedures 63
To Next Page
Loading...
