4. Lift the side of the system board upward (5), and then pull the system board away from the connectors
on the side of the computer to remove it (6).
Reverse this procedure to install the system board.
Speaker
To remove the speaker, use this procedure and illustration.
Table 6-10 Speaker description and part number
Description Spare part number
Speaker M21400-001
Before removing the speaker, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 39).
2. Remove the bottom cover (see Bottom cover on page 39).
3. Remove the battery (see Battery on page 49).
4. Remove the system board (see System board on page 57).
NOTE: Be sure that the RTC battery remains connected to the system board.
Remove the speaker:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the speaker to the computer.
60 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
