12. If you need to remove the ambient light sensor board, disconnect the cable from the ZIF connector on
the sensor (1), and then use a tool (2) to release the board from the display (3).
The ambient light sensor is available as spare part number N00883-001. The ambient light cable is
available in the display cable kit as spare part number N00098-001.
13. If you need to remove the display panel/camera cable, peel the cable up o the inside of the display rear
cover.
The display panel/camera cable is available as spare part number N00098-001.
70 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
