Fingerprint reader assembly
Description Spare part number
Fingerprint reader assembly (includes cable) 821693-001
Fingerprint reader bracket
NOTE: The ngerprint reader bracket is included in the Plastics Kit.
821675-001 (Plastics Kit)
Before removing the ngerprint reader assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 30).
5. Remove the battery (see Battery on page 35).
6. Remove the system board (see System board on page 61).
Remove the ngerprint reader assembly:
1. Remove the Phillips M2.0x2.0 screw (1) that secures the bracket to the computer.
2. Lift the bracket o the ngerprint reader board (2).
3. Remove the ngerprint reader board and cable assembly from the computer (3).
Reverse this procedure to install the ngerprint reader assembly.
66 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
