3. Pivot the battery up and back and then remove the battery (2).
Reverse this procedure to install the battery.
Service cover
NOTE: The service cover spare part kit includes 6 captive retention screws and 2 rubber feet.
Description Spare part number
With icons 753713-001
Without icons 799568-001
Before removing the service cover, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see Battery on page 29).
Remove the service cover:
1. Press on the memory card bezel (1) once to release the bezel, and then press on the bezel again to
remove the bezel.
2. Remove the two large rubber screw covers (2).
3. Remove the two small rubber screw covers (3).
The large and small rubber screw covers are included in the Plastics/Rubber Kit, spare part number
716744-001.
30 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
