6. Detach the left (2) and right edges of the hinge cover from the computer.
7. Remove the hinge cover (3) by sliding it away from the computer.
8. Remove the hinge cap (4).
Reverse this procedure to install the hinge cover and hinge cap.
Display assembly
Description Spare part number
Display assembly, 11.6-in, HD, (1366×768), LED, LVDS, UWVA , ultraslim display (includes display hinge,
microphone, webcam, and Windows button)
801799-001
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see Battery on page 29), and then remove the following components:
a. Service cover (see Service cover on page 30)
b. Solid-state drive (see Solid-state drive on page 36)
c. Keyboard (see Keyboard on page 41)
d. Bottom cover (see Bottom cover on page 44)
e. System board (see System board on page 50)
f. Hinge cover and hinge cap (see Hinge cover on page 55)
Remove the display assembly:
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
