Reverse this procedure to install the keyboard.
Bottom cover
Description Spare part number
Bottom cover (includes battery release latch) 753715-001
Before removing the bottom cover, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see Battery on page 29).
5. Remove the service cover (see Service cover on page 30).
6. Remove the keyboard (see Keyboard on page 41).
NOTE: When replacing the bottom cover, be sure that the NFC board is removed from the defective bottom
cover and installed on the replacement bottom cover. See NFC board on page 40 for NFC board removal
instructions.
Remove the bottom cover:
1. Remove the two Phillips PM2.0×4.4 screws that secure the bottom cover to the computer.
2. Close the computer.
3. Turn the computer upside down, with the rear toward you.
44 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
