HP EliteDesk 705 G5

Drives
For a list of available drives, see Computer major components on page 6.
Drive positions
Table 4-2 Identifying drives
Drive positions
1 3.5 inch hard drive bay
2 9.5 mm slim optical drive bay
NOTE: The drive conguration on your computer might be dierent than the drive
conguration shown above.
Installing and removing drives
When installing drives, follow these guidelines:
● The primary Serial ATA (SATA) hard drive must be connected to the dark-blue primary SATA connector on
the system board labeled SATA0.
● Connect an optical drive to one of the SATA connectors on the system board labeled SATA1 and SATA2.
IMPORTANT: To prevent loss of work and damage to the computer or drive:
If you are inserting or removing a drive, shut down the operating system properly, turn o the computer, and
unplug the power cord. Do not remove a drive while the computer is on or in standby mode.
Before handling a drive, be sure that you are discharged of static electricity. While handling a drive, avoid
touching the connector. For more information about preventing electrostatic damage, see Electrostatic
discharge information on page 12.
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic elds such as
monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the
package “Fragile: Handle With Care.”
Drives 35