1. Install mounting screws on the sides of the hard drive using standard 6-32 silver-and-blue mounting
screws.
NOTE: 6-32 mounting screws can be purchased from HP.
If you are replacing a drive, transfer the mounting screws from the old drive to the new drive.
● Install four silver-and-blue 6-32 mounting screws (two on each side of the drive).
● You can also install a 2.5 inch hard drive into a 3.5 inch drive bay using an adapter bracket similar
to the following example.
– Slide the 2.5 inch drive into the 3.5 inch adapter bracket.
Drives 41
To Next Page
Loading...
