Installing additional memory
The computer comes with small outline, dual inline memory modules (SODIMMs).
SODIMMs
The memory sockets on the system board can be populated with up to two industry-standard SODIMMs.
These memory sockets are populated with at least one preinstalled SODIMM. To achieve the maximum
memory support, you can populate the system board with up to 32 GB (EliteDesk 800 and ProDesk 600) or 16
GB (EliteDesk 705 and ProDesk 400) of memory.
SODIMM specications
For proper system operation, the SODIMMs must meet the following qualications:
EliteDesk 800 and ProDesk 600 EliteDesk 705 ProDesk 400
SODIMM 1.2 volt DDR4-SDRAM DIMMs 1.5 volt DDR3-SDRAM DIMMs or 1.35
volt DDR3L-SDRAM (Low Power)
DIMMs
1.2 volt DDR4-SDRAM DIMMs
Compliance unbuered non-ECC PC4-17000
DDR4-2133 MHz-compliant
unbuered non-ECC PC3-12800
DDR3/DDR3L-1600 MHz-compliant
unbuered non-ECC PC4-17000
DDR4-2133 MHz-compliant
Pins industry-standard 288-pin
containing the mandatory Joint
Electronic Device Engineering
Council (JEDEC) specication
industry-standard 240-pin
containing the mandatory Joint
Electronic Device Engineering
Council (JEDEC) specication
industry-standard 288-pin
containing the mandatory Joint
Electronic Device Engineering
Council (JEDEC) specication
Support support CAS latency 15 DDR4 2133
MHz (15-15-15 timing)
support CAS latency 11 DDR3/
DDR3L 1600 MHz (11-11-11 timing)
support CAS latency 15 DDR4 2133
MHz (15-15-15 timing)
Slots 2 2 2
Maximum
Memory
32 GB 16 GB 32 GB
Supported 512 Mbit, 1 Gbit, and 2 Gbit non-ECC memory technologies single-sided and double-sided DIMMs
Note The system will not operate properly if you install unsupported DIMM memory. DIMMs constructed with x8 and x16
DDR devices are supported; DIMMs constructed with x4 SDRAM are not supported.
HP oers upgrade memory for this computer and advises that the consumer purchase it to avoid
compatibility issues with unsupported third-party memory.
Installing additional memory 13
To Next Page
Loading...
Need help?
General
