HP EliteDesk 800 G2 SFF

Small bae
The small bae sits between the fan sink and the rear of the computer.
1. Prepare the computer for disassembly (Preparation for disassembly on page 18).
2. Remove the access panel (Access panel on page 19).
3. Rotate the bae upward.
4. Pull the bae away from the rear of the computer to disengage the clips on the bae from the rear of
the computer.
To install the small bae, reverse the removal procedure.
48 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis