Card reader
The card reader is attached to the front of the chassis under the rotating drive cage.
1. Prepare the computer for disassembly (Preparation for disassembly on page 18).
2. Remove the access panel (Access panel on page 19).
3. Remove the front bezel (Front bezel on page 19).
4. Rotate the drive cage to its upright position.
5. From the outside, front of the chassis, remove the Torx T15 screw that secures the card reader.
6. From the inside of the chassis, disconnect the card reader cable from the white system board labeled SD
RDR, and then press the tab on the side of the card reader (1) and slide the card reader out the front of
the chassis (2).
To install the card reader, reverse the removal procedures.
56 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
To Next Page
Loading...
