HP EliteDesk 800 G2 SFF

Fan bae
The fan bae sits on top of the fan sink.
1. Prepare the computer for disassembly (Preparation for disassembly on page 18).
2. Remove the access panel (Access panel on page 19).
3. Rotate up or remove the small bae (Small bae on page 48).
4. Remove the power cable from the clips on top of the bae (1).
5. Pull the two tabs away from the fan (2), and then lift the bae o the fan sink and out of the computer
(3).
To install the fan bae, reverse the removal procedure.
Fan bae 49