Hood lock
The hood lock is secured to the back of the computer.
1. Prepare the computer for disassembly (Preparation for disassembly on page 17).
2. Remove the access panel (Access panel on page 18).
3. Disconnect the cable from the system board connector labeled HLCK (1), and then remove the cable
from the clip on the fan duct (2).
4. Remove the screw that secures the hood lock to the rear of the computer (3), and then remove the hood
lock from the inside of the computer
(4).
To install the hood lock, reverse the removal procedure.
Hood lock 47
To Next Page
Loading...
