Camera
To replace the camera:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 17).
2. Insert a paper clip into the release holes on each side of the camera (1) to disengage the internal
latches, and then pull the camera out of the display head (2).
3. Insert the new webcam into the camera slot on the display head and press the webcam down so that it
engages the internal latches.
4. Reconnect the power cord and any external devices, and then turn on the computer.
To install a webcam when a camera blank is installed in the camera slot on the display head:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 17).
2. Remove the display head rear panel (see Display head rear panel on page 31).
32 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
