Solid-state drive (SSD)
NOTE: The solid-state drive spare part kit does not include the cable, bracket, or screws. These
components are included in the Solid-state Drive Hardware Kit, spare part number 777653-001.
Description Spare part number
256-GB solid-state drive, TLC 777651-001
256-GB solid-state drive, MLC 777652-001
Solid-state Drive Hardware Kit (includes cable, bracket, and screws) 777653-001
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the top cover (see
Top cover on page 28).
5. Disconnect the battery.
Remove the solid-state drive:
1. Disconnect the cable (1) from the system board.
2. Remove the two Phillips PM2.5×4.0 screws (2) that secure the solid-state drive bracket to the
computer.
36 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
45 / 85 44 / 83 45 / 85
To Next Page
Loading...
