5. Disconnect the battery.
6. Remove the WLAN module (see WLAN module on page 38).
7. Remove the system board (see
System board on page 47).
Remove the memory module:
1. Position the system board upside-down.
2. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The memory module tilts up.)
3. Remove the memory module (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install a memory module.
50 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
59 / 85 58 / 83 59 / 85
To Next Page
Loading...
