ENWW Using the Embedded Web Server 106
Operating Notes
● If you enter or change a configuration parameter value, click
Apply to enable your change, or click Cancel to erase your
change.
● Changes to the IP address will close the connection to the
embedded Web server. To re-establish a connection, use the new
IP address.
CAUTION Changes to the IP address on the HP Jetdirect print
server may result in printing failures for clients
that have been configured to print to this printer
using the previous IP address.
● The embedded Web server provides access to wireless network
connection parameters on HP Jetdirect wireless print servers.
CAUTION If you change the wireless network settings, you
may lose your connection. To reconnect, you may
need to adjust your system to the new settings.
If the print server loses its network connection, you
may need to reset it to a factory-default state and
reinstall it.
● Features and configuration parameters not supported by
value-based print servers, such as HP ew2400, will not appear.
● Novell NetWare networks: On the Network Settings page, use
the IPX/SPX tab to configure Novell Directory Services (NDS)
Queue Server mode parameters. Note that the embedded Web
server cannot create NDS objects (print server, printer, and print
queue objects) on the Novell server. To create these objects, use
a Novell NetWare utility, such as NWAdmin, or configure the
IPX/SPX stack for NDS through HP utilities, such as HP Web
Jetadmin.
To Next Page
Loading...
Need help?
General
