ENWW Using the Embedded Web Server 117
TTL/SLP Specifies the IP multicast Time To Live (TTL) discovery setting
for Service Location Protocol (SLP) packets. The default value is
4 hops (the number of routers from the local network). The range
is 1-15. If set to -1, multicast capability is disabled.
For print servers configured for Auto IP (link-local) addresses, this
field will be ignored. TTL on outbound packets will always be set
to 255 and limited to the link-local network.
System Contact Identifies a person who is assigned to administer or service this
device. This field may include a phone number or similar
information.
When configured, this parameter will be displayed on the
HP Jetdirect home page.
System Location Specifies the physical location of the device or related
information. Only printable ASCII characters are allowed, up to 64
characters.
When configured, this parameter will be displayed on the
HP Jetdirect home page.
Banner Page Specifies whether to enable or disable printing of an LPD banner
page for print jobs. For currently supported print servers, only a
single port is available (Port 1).
Default IP Specifies the IP address to use when the print server is unable
to obtain an IP address from the network during a forced TCP/IP
reconfiguration (for example, when manually configured to use
BOOTP/DHCP).
LEGACY DEFAULT_IP: sets the legacy default IP address
192.0.0.192.
AUTO_IP: sets a link-local IP address 169.254.x.x.
The initial setting is determined by the IP address obtained when
first powered on.
Send DHCP
requests
A checkbox is used to specify whether DHCP requests will be
periodically transmitted when a legacy default IP address
192.0.0.192 or link-local IP address 169.254.x.x has been
automatically assigned.
Clear the checkbox to disable DHCP requests.
Check the checkbox (default) to enable DHCP requests.
Table 4.4 TCP/IP Settings (3 of 3)
Item Description
To Next Page
Loading...
Need help?
General
