HP Ew2400 - JetDirect Print Server User Manual

ENWW TCP/IP Configuration 53
TCP/IP Access Control
allow: netnum [mask]
Makes an entry into the host access list stored on the HP Jetdirect print server.
Each entry specifies a host or network of hosts that are allowed to connect to the
printer. The format is “allow: netnum [mask]” where netnum is a network number
or host IP address, and mask is an address mask of bits applied to the network
number and host address to verify access. Up to 10 access list entries are allowed.
If there are no entries, all hosts are permitted access. For example,
allow: 192.0.0.0 255.0.0.0 allows hosts on network 192.
allow: 192.168.1.2 allows a single host. In this case, the default mask
255.255.255.255 is assumed and is not required.
allow: 0 This entry clears the host access list.
For additional information, see Chapter 7
.
TCP/IP Other Settings
syslog-config:
Enables or disables syslog server operation on the print server: 0 disables,
1 (default) enables.
syslog-svr:
(syslog-srv:)
The syslog server’s IP address. It specifies the server that the HP Jetdirect print
server sends syslog messages to. For more information, see Appendix A
.
syslog-max:
Specifies the maximum number of syslog messages that can be sent by the
HP Jetdirect print server on a per-minute basis. This setting allows administrators
to control the log file size. The default is 10 per minute. If it’s set to zero, the number
of syslog messages is not restricted.
syslog-priority:
Controls the filtering of syslog messages sent to the syslog server. The filter
range is 0 to 8, with 0 being the most specific and 8 the most general. Only
messages that are lower than the filter level specified (or higher in priority) are
reported. The default is 8, messages of all priorities are sent. If 0, all syslog
messages are disabled.
syslog-facility:
A code used to identify the source facility of a message (for example, to identify
the source of selected messages during troubleshooting). By default, the
HP Jetdirect print server uses LPR as the source facility code, but local user values
of local0 through local7 can be used to isolate individual or groups of print servers.
slp-config:
Enables or disables the Service Location Protocol (SLP) operation on the print
server: 0 disables, 1 (default) enables.
Table 3.3 TFTP Configuration File Parameters (4 of 12)

HP Ew2400 - JetDirect Print Server Specifications

General

Brand	HP
Model	Ew2400 - JetDirect Print Server
Category	Print Server
Language	English