ENWW TCP/IP Configuration 54
slp-keep-alive:
Specifies a time period for the print server to send multicast packets on the network
to prevent being deleted from network device tables. Some infrastructure devices,
such as switches, may delete active devices from their device tables due to
inactivity on the network. To enable this feature, set a value from 1 to 1440 minutes.
Set 0 to disable this feature.
ttl-slp:
Specifies the IP multicast “Time To Live” (TTL) setting for Service Location Protocol
(SLP) packets. The default value is 4 hops (the number of routers from the local
network). The range is 1-15. When set to a -1, multicast capability is disabled.
mdns-config:
Enables or disables Multicast Domain Name System (mDNS) services. 0 disables,
1 (default) enables. mDNS is typically used on small networks for IP address and
name resolution (through UDP port 5353) where a conventional DNS server is
neither used or available.
mdns-service-name:
Specifies an alphanumeric string of up to 64 ASCII characters assigned to this
device or service. This name is persistent and is used to resolve a particular device
or service if socket information (such as the IP address) changes from session to
session. Apple Rendezvous will display this service. The default service name is
the printer model and the LAN Hardware (MAC) address.
mdns-pri-svc:
Specifies the mDNS highest priority service to use for printing.To set this
parameter, choose one of the following printing option numbers:
1: Port 9100 printing
2: IPP port printing
3: The default LPD raw queue
4: The default LPD text queue
5: The default LPD auto queue
6: The default LPD binps (binary postscript) queue
7 through 12: If user-specified LPD queues are defined, corresponds to
user-specified LPD queues 5 through 10.
The default selection will depend on the printer, typically port 9100 printing or LPD
binps.
ipv4-multicast:
Enables or disables the receipt and transmission of IP version 4 multicast packets
by the print server. 0 disables, 1 (default) enables.
Table 3.3 TFTP Configuration File Parameters (5 of 12)
To Next Page
Loading...
Need help?
General
