ENWW TCP/IP Configuration 60
usb-mode:
Specifies the communication mode over the USB port on the HP Jetdirect print
server.
● Auto (default): Automatically negotiates and sets the the highest
communication mode possible for the attached printer or device.
● MLC: (Multiple Logical Channels) An HP-proprietary communication mode that
allows multiple channels of simultaneous print, scan and status
communications.
● BIDIR: A standard connection that supports bi-directional communications
between the printer and print server. The print server sends print data and
receives status from the printer.
● UNIDIR: A standard connection in which data is transferred in one direction
only (to the printer).
status-page-lang:
Specifies the page description language (PDL) that the print server will use to send
the Jetdirect configuration/status page to the printer.
● Auto (default): The PDL is auto-detected when the print server is powered on
or after a cold-reset.
● PCL: Hewlett-Packard Printer Control Language
● ASCII: Standard ascii characters
● HPGL2: Hewlett-Packard Graphics Language (v2)
● PS: Postscript language
network-select:
(For HP Jetdirect products with a dual wired/wireless port, such as model ew2400)
Specifies the active behavior of the print server.
● Auto (default): Automatically detects whether a network cable is attached. If a
network cable is not attached, only the IEEE 802.11g wireless port will be
active. However, if a network cable is attached, then only the IEEE 802.3 wired
port will be active. Use caution when plugging in a network cable on an
active wireless network. Wireless access to the device will be terminated.
● Wired: Only the 802.3 wired port will be active.
● Wireless: Only the 802.11g wireless port will be active.
Table 3.3 TFTP Configuration File Parameters (11 of 12)
To Next Page
Loading...
