ENWW TCP/IP Configuration 82
wpa-auth-type This command is not compatible with the Shared Key
authentication option in the auth-type command. Use this
command to specify WPA-PSK authentication.
PSK: WPA-PSK provides enhanced authentication where
an authentication server is not used. Instead, a Pre-shared
key provides device authentication. A Pre-shared key is
generated when you specify a network pass-phrase using
the psk-passphrase command. The dynamic-encrypt
command should be set to the Robust option.
psk-passphrase Specify a pass-phrase that is used to generate a network
Pre-shared key. A pass-phrase must be from 8 to 63 ASCII
characters in the hexadecimal range 21 through 7E
(characters 0-9, a-z, A-Z and numerous special characters
including !, @, #, $, %, ^, &, (, ), _, +, =, -, {, }, [, ], \, /, “, <,
>, ?, “, ‘, ~).
dynamic-encrypt For WPA-PSK authentication, use this command to set the
print server for dynamic Wi-Fi Protected Access (WPA)
encryption. Specify Robust as the command option.
802.11 Wireless Diagnostics
Command Description
Current SSID (Read-only parameter) The network name (SSID) to which
the wireless print server connected.
Current Channel (Read-only parameter) The channel that the wireless print
server is currently using.
Signal Strength (Read-only parameter) The strength of the radio signal
received by the print server.
<blank>: No radio signal detected while the print server is
scanning.
No Signal: No radio signal detected on any channel.
Poor/Marginal/Good/Excellent: Indicates the detected
signal strength level.
Access Point Mac (Read-only parameter) The Media Access Control (MAC)
address of the Access Point used for Infrastructure mode
communications. For example,
00:a0:f8:38:7a:f7
specifies that the Access Point with MAC address
00a0f8387af7 was used for communicating on the network.
Table 3.4 Telnet Commands and Parameters (4 of 18)
To Next Page
Loading...
Need help?
General
