EasyManuals Logo

HP Ew2400 - JetDirect Print Server User Manual

HP Ew2400 - JetDirect Print Server
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #83 background imageLoading...
Page #83 background image
ENWW TCP/IP Configuration 83
TCP/IP Main
Command Description
host-name Alphanumeric string (up to 32 characters), to assign or
change the name of the network device. For example,
“host-name printer1” assigns the name “printer1” to the
device. The default host name is NPIxxxxxx, where xxxxxx
are the last six digits of the LAN hardware (MAC) address.
ip-config Specify the configuration method:
manual: The print server will wait for IP parameters using
manual tools (such as Telnet, embedded Web server,
control panel, installation/management software). Status
will be User Specified.
bootp: The print server will send BOOTP requests on the
network for dynamic IP configuration.
dhcp: The print server will send DHCP requests on the
network for dynamic IP configuration.
auto_ip: The print server will be automatically configured
with a unique link-local address 169.254.x.x.
ip IP address for the print server, in dotted notation. For
example:
ip-config manual
ip 192.168.45.39
where ip-config specifies manual configuration and ip
manually sets the IP address 192.168.45.39 on the print
server.
Specifying 0.0.0.0 clears the IP address.
If you exit and save a new IP address, it must be specified
on the next Telnet connection.
subnet-mask A value (in dotted notation) that identifies the network and
host portions of an IP address in received messages. For
example,
subnet-mask 255.255.255.0
stores the subnet mask value 255.255.255.0 on the print
server. The value 0.0.0.0 disables the subnet mask. For
more information see Appendix A
.
default-gw The IP address of a default gateway, in dotted notation.
For example,
default-gw 192.168.40.1
assigns 192.168.40.1 as the IP address of the default
gateway for the print server.
Note: If the HP Jetdirect print server is configured by DHCP
and you manually change the subnet mask or the default
gateway address, you should manually change the print
server’s IP address. This will release the DHCP-assigned
address back to the DHCP IP address pool.
Table 3.4 Telnet Commands and Parameters (5 of 18)

Table of Contents

Other manuals for HP Ew2400 - JetDirect Print Server

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Ew2400 - JetDirect Print Server and is the answer not in the manual?

HP Ew2400 - JetDirect Print Server Specifications

General IconGeneral
BrandHP
ModelEw2400 - JetDirect Print Server
CategoryPrint Server
LanguageEnglish

Related product manuals