ENWW TCP/IP Configuration 87
slp-config Enables or disables the Service Location Protocol (SLP)
operation on the print server: 0 disables, 1 (default) enables.
SLP is used by selected HP software applications (through
UDP port 427) to automate device discovery.
slp-keep-alive Specifies a time period for the print server to send multicast
packets on the network to prevent being deleted from
network device tables. Some infrastructure devices, such as
switches, may delete active devices from their device tables
due to inactivity on the network. To enable this feature, set
a value from 1 to 1440 minutes. Set 0 to disable this feature.
mdns-config Enables or disables Multicast Domain Name System
(mDNS) services. 0 disables, 1 (default) enables. mDNS is
typically used on small networks for IP address and name
resolution (through UDP port 5353) where a conventional
DNS server is not available.
mdns-service-name Specifies an alphanumeric string of up to 64 ASCII
characters assigned to this device or service. This name is
persistent and is used to resolve a particular device or
service if socket information (such as the IP address)
changes from session to session. Apple Rendezvous will
display this service. The default service name is the printer
model and the LAN Hardware (MAC) address.
mDNS Domain
Name
(Read-only parameter) Specifies the mDNS domain name
assigned to the device, in the form <host name>.local. If a
user-specified host name has not been assigned, the default
host name NPIxxxxxx is used, where xxxxxx are the last 6
digits of the LAN hardware (MAC) address.
mdns-pri-svc Specifies the mDNS highest priority service to use for
printing.To set this parameter, choose one of the following
printing option numbers:
1: Port 9100 printing
2: IPP port printing
3: The default LPD raw queue
4: The default LPD text queue
5: The default LPD auto queue
6: The default LPD binps (binary postscript) queue
7 through 12: If user-specified LPD queues are defined,
corresponds to user-specified LPD queues 5 through 10.
The default selection will depend on the printer, typically port
9100 printing or LPD binps.
ttl-slp Specifies the IP multicast “Time To Live” (TTL) setting for
Service Location Protocol (SLP) packets. The default value
is 4 hops (the number of routers from the local network).
The range is 1-15. When set to a -1, multicast capability
is disabled.
Table 3.4 Telnet Commands and Parameters (9 of 18)
To Next Page
Loading...
Need help?
General
