ENWW TCP/IP Configuration 93
Status (Read-only parameter) Indicates the current AppleTalk
configuration status.
READY: Indicates the HP Jetdirect print server is awaiting
data.
DISABLED: Indicates that AppleTalk was manually
disabled.
INITIALIZING: Indicates that the print server is registering
the node address or name. An additional status message
may also be displayed.
DLC/LLC
Command Description
dlc/llc-config Enables or disables DLC/LLC protocol operation on the print
server. 0 disables, 1 (default) enables. For example,
dlc/llc-config 0 will disable DLC/LLC operation.
strict-8022 Controls DLC/LLC protocol interpretation:
0 (default): disables, that is, provides loose interpretation.
1: enables, that is, provides strict interpretation).
Other
Command Description
upgrade To configure one or more Jetdirect print servers with the
name and location of a firmware upgrade file.
CAUTION: Ensure that command parameters are properly
entered and that the upgrade file is a higher version than the
currently installed version. The print server will attempt to
upgrade when the upgrade file contains a higher version
than the installed version.
The command format is:
upgrade: <TFTP server IP> <Version> <Product Number>
<Filename>
where,
<TFTP Server IP> is the IP address of the TFTP server,
<Version> specifies the firmware version of the upgrade file,
<Product Number> specifies and must match the product
number of the print server,
<Filename> is the path and filename of the firmware
upgrade file.
laa Specifies a locally administered address (LAA) that replaces
the factory-assigned LAN Hardware (MAC) address. If LAA
is used, a user-specified string of exactly 12 hexadecimal
digits must be entered.
For Ethernet print servers, the LAA address must start with
hexadecimal X2, X6, XA, or XE, where X is any hexadecimal
digit 0 through F.
The default address is the factory-assigned address.
Table 3.4 Telnet Commands and Parameters (15 of 18)
To Next Page
Loading...
