HP f870x - 3.5 Parking Mode

38
3.5 Parking Mode
To monitor the vehicle when it is parked, you can activate Motion
Detection, or Vibration Detection.
Follow the steps below to change the settings for Parking Mode:
1. Press the button to
enter the main menu.
2. Press the or
button to select Parking
Mode, and then press the
button to confirm.
3. Press the or button to configure Parking Mode (Motion
Detection / Vibration Detection / Off), and then press the
button to complete setting.
4. Press the button to return to recording screen.
3.5.1 Using embedded battery of car camcorder
 Motion Detection:
- If disconnected external power supply when the camcorder is
powered on, the system alert message “ Press OK to power off
or enter Parking mode after 10 sec. ” This means the system will
enter Motion Detection automatically in 10 seconds, and then
LCD screen turns off (the camcorder will turn off the screen
temporarily, but still in standby detection status. Press any