HDD Troubleshooting Guide Page 16 of 48
• You will see a message like
“Estimated execution time
(min): 32”
NOTE: The displayed time is
the sum of the Quick + the
Comprehensive tests.
Press [F10] = Accept to launch
both tests.
The Quick DST starts first.
- If the hard disk drive has a
failure, the test stops and an
error message pops up.
- If the hard disk drive is good,
the test finishes within 2
minutes.
Then the Comprehensive DST
starts automatically.
- If the hard disk drive has a
failure, the test stops and an
error message pops up.
NOTE: the user can stop the test
at any time by pressing the
[ESC] = Cancel key.
Hewlett-Packard Setup Utility
File St Security Power Advance
<F1=Help>
Device Configuration
Storage Options
DPS Self-test
Storage
Boot Order
F10=Accept, ESC=Cancel
Estimated execution time (in minutes): 32
Pres F10 to continue, or ESC to cancel
DPS Self-test
Hewlett-Packard Setup Utility
File Storage Security Power Advance
<F1=Help>
Device Configuration
Storage Options
DPS Self-test
Storage
Boot Order
ESC=Cancel
Performing test 1 …
……………………………
40%
DPS Self-test
Hewlett-Packard Setup Utility
File Storage Security Power Advance
<F1=Help>
Device Configuration
Storage Options
DPS Self-test
Storage
Boot Order
ESC=Cancel
Performing test 2 …
……………………………
40%
DPS Self-test