HP Integrity rx2660 Installation Guide

4 Removing the Server from the Pedestal Kit
Use this chapter to remove the server from the pedestal kit.
The following are the high-level procedures needed to remove the rx2660 server from the pedestal
kit.
1. Remove pedestal feet.
2. Remove the pedestal side pieces.
3. Remove the bezel cover.
4. Remove the pedestal top piece.
5. Remove the pedestal bottom piece.
Required Tools
The only tool required for disassembling the pedestal kit is:
• Flat head screwdriver
Powering Off the Server and Removing Cables
Use the following procedures to power off the server and remove the cables from the server.
1. Power down the server using the instructions provided in the HP Integrity rx2660 Server
User Service Guide.
2. Disconnect the power and LAN cables connected to the server.
16 Removing the Server from the Pedestal Kit

HP Integrity rx2660 Specifications

General

Brand	HP
Model	Integrity rx2660
Category	Server
Language	English