HP Integrity Superdome X - Page 69

0 0 0 0
8D - 11D - 14D - 17D
0 0 0 0
3E - 4E - 21E - 22E
0 0 0 0
9F - 10F - 15F - 16F
0 0 0 0
CPU1: 1A - 6A - 19A - 24A
0 0 0 1
7B - 12B - 13B - 18B
0 0 0 0
2C - 5C - 20C - 23C
0 0 0 0
8D - 11D - 14D - 17D
0 0 0 0
3E - 4E - 21E - 22E
0 0 0 0
9F - 10F - 15F - 16F
0 0 0 0
Manageability HW
- SubFru Isolation -
- Blade -
- Manageability HW –
-0- -1- -2-
CamNet: 0 0 .
LOM: 0 0 0
-----------------------------
COMPONENT: Fault
---
NOTE:
For Integrity Superdome X, there are FlexLOMs instead of LOMs. Each FlexLOM has its own
physical location. Therefore, indictments against FlexLOMs are issued against the FlexLOM
physical location, rather than indicting the blade and setting one of the LOM bits. The blade SubFru
isolation display will continue to show LOM bits, but these should always have a value of 0.
Components supported by this display are as follows:
• PDHC
• OA_LAN
• USB
• NAND_Flash
• NOR_Flash
• SRAM
• PDH_FPGA
• LPM_FPGA
• RTC
• PDH_SRAM
• iLO
Agent fabric
- SubFru Isolation -
- Blade -
- XNC -
-------------------------------
Troubleshooting 69