NOTE: For creating partnerships with cellular phones, it is mandatory that you provide a numeric
passcode.
5. Enter the same passcode on the other device.
6. Tap Done.
If you cannot discover another device, try the following:
●
Make sure Bluetooth is turned on.
●
Move the devices closer to each other.
●
Make sure the device you are attempting to connect is on and is visible to other devices.
End a Bluetooth partnership
To delete a Bluetooth partnership:
1. Tap Start > Settings > Connections > Bluetooth.
2. Tap and hold the partnership to delete.
3. Tap Delete.
4. Tap Yes.
Accept a Bluetooth partnership
To accept a Bluetooth partnership:
1. Make sure that your HP iPAQ is visible and within close range (up to 10 meters, or about 30 feet)
of the pairing device.
a. Tap Start > Settings > Connections > Bluetooth > Mode.
b. Select the Make this device visible to other devices check box.
c. Tap ok.
2. When prompted to accept a partnership with the device that is requesting the relationship, tap Yes.
3. If a passkey is requested, enter an alphanumeric passkey between 1 and 16 characters in
Passkey box, and then tap Next. Enter the same passkey in the device that requests the
partnership. Using a passkey provides greater security.
4. Tap Done.
Edit a Bluetooth partnership
To rename a Bluetooth partnership:
1. Tap Start > Settings > Connections > Bluetooth.
2. Tap and hold the partnership to edit.
3. Tap Edit.
4. In the Display Name box, enter a new name for the partnership.
5. Tap Save.
68 Chapter 13 Connections
To Next Page
Loading...
Need help?
General
