Configuring an iSCSI device 6
Configuring an iSCSI device
iSCSI configuration through the NCU
Complete the steps in the following sections to enable and configure an iSCSI device or to view iSCSI
information through the NCU.
Install the Network Configuration Utility software
If you do not have HP NCU software installed on your server, complete the following steps to install the
NCU for Windows operating systems:
1. Go to the HP website (http://www.hp.com).
2. Click Software & Driver Downloads from the left menu bar.
3. Type the product name in the For product box and press Enter. For example, type NC373T.
4. Select an operating system.
5. Click HP Network Configuration Utility.
6. Click download and save the HP SoftPaq (sp#####.exe) file to a directory on your hard drive. The
SoftPaq file is a self-extracting executable with a file name based on the SoftPaq number.
7. Click the SoftPaq file to extract the files and then open the cmponent.htm file.
iSCSI Settings tab
To enable iSCSI:
1. Select an HP Multifunction Adapter in the NCU Main window and click Properties to display the
Multifunction Adapter Properties Settings tab. Alternatively, hold down the Alt key and enter p to
display the Settings tab.
To Next Page
Loading...
Need help?
General
