Installing the software
for the HP Jetdirect 200m and 250m print servers
1. Choose the installation CD and run the installer.
Windows:
Use the CD that came with your printer (instead of the HP Jetdirect CD) if it is
available. The printer's CD has all the software you need for a complete network installation.
Insert the printer's CD into your computer's CD drive. The CD should start automatically and
offer you a choice of buttons — click on the Install button and follow the instructions on the
screen. (If the CD does not start automatically, double-click on the SETUP program on the CD.)
When the installer finishes and you can print to the network printer, you have completed the
installation.
If the printer's CD is not available, insert the HP Jetdirect (print server) CD and run its
installer. You will also need your printer's driver; if you don't have it, you can get it from the Web
at
http://www.hp.com/cposupport/software.html.
MacOS:
Install the printer driver from the CD that came with the printer. That driver provides
connection to your network printer via the AppleTalk protocol. If the printer's CD is not
available, you can get the driver from the Web at
http://www.hp.com/cposupport/software.html.
If you need to print via the IP protocol, use the LaserJet utility on the HP Jetdirect (print server)
CD.
For general information on setting up network printing on Macintosh systems,
click here.
2. Set up other computers as needed. In step 1, above, you installed the network printing
software on a single computer. For a network with several computers that will use the same
network printer, you will need to set up that printer on the remaining computers. The setup
procedure you use depends on whether you are using peer-to-peer or client-server printing.
To Next Page
Loading...
Need help?
General
