HP Jet Fusion 4200 - Printer Site Preparation Requirements

2 Site preparation requirements for the printer
Physical space requirements
Unloading route
The printer is commonly delivered by truck. The reception area and the entrance to the site should be
unobstructed and ready to receive delivery.
The route between the unloading area of the printer and the installation site, including any corridors and
doorways through which the printer must be transported, is important to proper site preparation and must be
planned before the arrival of the printer. This pathway must be clear when the printer arrives.
Printer physical
specications with packaging
Width with packaging 2300 mm (90.55 in)
Depth with packaging 1325 mm (52.17 in)
Height with packaging 2068 mm (81.42 in)
Weight with packaging 945 kg (2083 lb)
For the specications without packaging, see Load bearing on page 9 and Designing the optimal print-
production area on page 10.
Doorway
specications
Minimum doorway width 2320 mm (91.34 in) with packaging
1202 mm (47.32 in) without packaging
Minimum doorway height 2088 mm (82.20 in) with packaging
1435 mm (56.50 in) without packaging
Minimum corridor width with right-angled bend 1520 mm (59.84 in) without packaging
The printer can be moved on the pallet up or down a ramp of no more than 10° inclination.
Unpacking and moving the printer
You are strongly recommended to unpack the printer where it will be used, or as close to that location as
possible.
8 Chapter 2 Site preparation requirements for the printer ENWW