3 Site preparation requirements for the
processing station
NOTE: If you have the HP Jet Fusion 5200 3D Processing Station, refer to the HP Jet Fusion 5200 Series 3D
Printing Solution Site Preparation Guide.
Physical space requirements
Unloading route
The route between the unloading area of the processing station and the installation site, including any corridors
and doorways through which the station must be transported, is important to proper site preparation and must
be planned before the arrival of the station. This pathway must be clear when the station arrives.
CAUTION: For the 4210, check the measurements of the material supply that you are going to use, and bear in
mind where you are going to use it.
Processing station physical specications with packaging
Width with packaging 2384 mm (93.86 in)
Depth with packaging 1176 mm (46.30 in)
Height with packaging 2181 mm (85.87 in)
Weight with packaging 550 kg (1213 lb)
For the specications without packaging, see Load bearing on page 24 and Designing the optimal print-
production area on page 26.
Doorway
specications
Minimum doorway width 1196 mm (47.09 in) with packaging
940 mm (37.01 in) before assembling the material cartridge support
800 mm (31.50 in) without packaging and after disassembling some parts
Minimum doorway height 2201 mm (86.65 in) with packaging
2000 mm (78.74 in) as removed from the packaging before starting installation
2400 mm (94.49 in) without packaging and mixer upwards
Minimum corridor width with right-angled bend 1750 mm (68.90 in) with packaging
ENWW Physical space requirements 23
To Next Page
Loading...