HP Jet Fusion 4200 - Printer Load Bearing Requirements; Printer Floor Surface Requirements

IMPORTANT: The printheads should never be moved inside the printer, they should always be moved in their
original packaging and installed at the nal location.
The space required for assembly is 5.5 × 3 m (217 × 118 in).
Moving equipment
If you need to move the printer after unpacking, take into account the following considerations:
● Ground-oor installation: The printer can be moved on wheels up or down a ramp of no more than 10°
inclination.
● Above-ground installation: Use an elevator if the printer can t inside it while remaining horizontal (without
tilting the printer), and if it can support the weight. Otherwise, you may need a crane; contact your reseller
for more information.
CAUTION: The printer is heavy and can easily fall over. Moving it over a ramp or tilted oor increases the risk.
Move it smoothly, maintain safety precautions for people in the vicinity, and secure it against overbalancing.
Always move it parallel to its length.
CAUTION: If you need to move the printer on its wheels to its nal position, move it down from the pallet but do
not remove all the transport protections and locks.
CAUTION: Unloading and moving the printer and all system components is the customer's responsibility and
not HP's. Failure to provide the required moving and lifting equipment could result in personal injury or printer
damage during installation.
Load bearing
The load-bearing characteristics of the oor in the print-production area must be sucient to withstand the
weight of your printer. To calculate the load-bearing characteristics of the print-production oor, consult a
structural engineer.
Printer weight 750 kg (1653 lb)
Build unit weight (full) 185 kg (408 lb)
NOTE: Take into account that the build unit will be inserted inside the printer while printing. Therefore, you
must consider the sum of both weights inside the same footprint when the build unit is inserted.
Floor surface
The oor surface should have the following characteristics:
● Flat and horizontal
● Solid, smooth, and level
HP recommends Ff > 20 and Fl > 20, measured according to ASTM E1155M, to ensure that the oor is
suciently at and level. Otherwise the printer could malfunction.
● No holes or indentations
ENWW Load bearing 9