– Use hostnames or static IP addresses in devices and in the Command Center Server computer.
– The computer in which Command Center Server is installed should always be on, awake, and
connected to the Internet.
● If your network performs SSL/TLS inspection, you must congure the Command Center software to
support SSL bump with the certicate provided by your IT department.
● If your proxy requires authentication, you must congure the Command Center proxy tab with the
information supplied by your IT department.
Computer requirements
Command Center Server computer
HP recommends having only one computer running HP SmartStream3D Command Center Server. It should meet
these requirements:
● 24/7 uptime (it never switches o or goes to sleep)
● 24/7 access to the HP Cloud
● Local network access to all HP 3D devices
● Intel Core processor with four virtual cores/threads
● Computer running Windows 10 (64-bit) or Windows Server 2012 R2
● 8 GB RAM
● 400 GB available hard disk space
Command Center Client computers
Bear in mind that you can run this software in as many computers as required.
Each of the computers running HP SmartStream 3D Command Center Client should meet these requirements:
● Local network access to the computer running HP SmartStream 3D Command Center Server
NOTE: No connection to any printer is required.
● Intel Core processor with four virtual cores/threads
● Computer running Windows 10 (64-bit) or Windows Server 2012 R2
● 8 GB RAM
● 400 GB available hard disk space
Local network
The local network(s) interconnecting the computers running HP SmartStream 3D Command Center and the
printers must meet the following requirements:
● Ethernet (IPv4) connection, at least 100 MB/s
40 Chapter 4 Plan your computer and network environment ENWW
To Next Page
Loading...